| Author |
Message |
admin
Site Admin
Joined: 09 Mar 2008
Posts: 408
Location: In my garage |
|
 LRP X11 screws coming out !!! |
 |
I have an LRP X11 13.5 which has a problem with the long screws which hold on the front of the can .... They are just spinning when you try to tighten them up
Do they just screw into plastic in the sensor end of the can ???
I have taken both ends off but you can't get it apart enough to see what the problem is ...
Can anything be done to change where the screws locate or is it ready for the BIN
Any Help would be Good Thanks ......... 
_________________
Sponsored By Demon Products & My Pocket
Numb Nuts Tri Club 2007 /2008 Pro Stock Champion
. |
|
| Sat Jun 21, 2008 6:17 am |
    |
 |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
